skip to Main Content
NOSTOP Cut Waterless Processing

Cutting sizes from 150mm to 3200mm
Splitting sizes from 200mm to 3200mm
Up to 8 powered heads – 6 fixed engraving heads

incisione-spacco-continuo-macchina

Machine to obtain sub-sizes through splitting.

Dry pre-cutting and engraving

incisione-spacco-in-continuo-pretaglio

The machine can operate in two modes and meet a wide range of production needs:

Pre-cut + engraving: the tools equipped with discs make partial cuts on the bottom; subsequently, incipient fractures are made on these cuts by means of engraving heads.

Engraving: is carried out only by means of engraving heads so as to make incipient fractures directly onto the original surface of the material. The above operating mode can only be applied to smooth, even surfaces, free of internal tensions.

Pre-cutting and engraving head

TESTA INCISORE

Powered cutting unit with electric spindles with fixture for cutting discs. At the base of each cutting head is mounted a bar with press rolls that hold in line the material during machining, absorbing the stresses transmitted by the tool.
The idle heads have the opportunity to bring two different types of engravers, one with a greater diameter for smooth or one with a smaller diameter, used for efficiently engraving even uneven surfaces.

Roller splitting

incisione-spacco-in-continuo-spacco-rullo

The machine is used to split ceramic slabs along one or more incipient fractures made previously. The slab is split without stopping its forward motion along the line.

Roller splitting

incisione-spacco-in-continuo-spacco-rullo2

The slab, carried by a conveyor belt, passes through 3 cross rollers with independent adjustment systems, placed two above and one below the conveyor belt to create a condition of interference which causes the rupture along the incipient fracture lines.

Complete module

incisione-spacco-continuo-modulo-completo

Engraving and cutting with automatic dynamic tile centring device with pneumatic actuator and handwheel adjustment.
Splitting unit consisting of 2 upper rollers with horizontal position adjustment system made up of electric jacks that adjust the machine for cutting slabs of different sizes. 1 bottom roller with vertical adjustment system made of a manual jack that adjusts the machine for cutting slabs of various thicknesses.

Download the section of the corresponding catalog in PDF

pdf
Back To Top